Mazdaspeed6 L4-2.3L Turbo (2006)
1. Support the trailing link and the knuckle component with a jack.
2. Remove the lower shock absorber bolts.
Bolt (Lateral Link (Outer)) Removal Note
1. Loosen the lateral link bolts (inner).
2. Remove the lateral link bolts (outer), and remove the lateral link (outer) from the knuckle.
Bolt (Trailing Link (Front)) Removal Note
Warning:
^
Be sure that the trailing link and the knuckle component are supported securely with a jack. Otherwise, the trailing link and/or the
knuckle component may fall, causing death or injury, or vehicle damage.
1. Verify that the trailing link and the knuckle component are supported securely with a jack, and remove the bolts at the trailing link front.
Wheel Hub Removal Note
1. Remove the wheel hub from the knuckle using the SSTs.
2. If the bearing inner race remains on the wheel hub, grind a section of the bearing inner race until approximately 0.5 mm (0.02 inch) remains. Then
remove it using a chisel.
Wheel Bearing Removal Note
