Mazdaspeed6 L4-2.3L Turbo (2006)
6. Make sure that the marks on the shock absorber and dust boot are aligned.
7. Install the mounting rubber an4,piston rod nut, then remove the SSTs.
Piston rod nut tightening torque 39.2 - 52.9 Nm (4.00 - 5.39 kgf-m, 29.0 - 39.0 ft. lbs.)
Front Shock Absorber and Coil Spring Installation Note
1. Install the stud bolts at a 27° - 33° angle from where the stabilizer control link is installed (center line), towards the inner side of the vehicle.
Damper Fork Installation Note
1. Align the gap of the damper fork with the projections of the damper
2. Tighten the bolt.
