Mazdaspeed6 L4-2.3L Turbo (2006)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
Front Shock Absorber and Spring Removal/Installation
FRONT SHOCK ABSORBER AND SPRING REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Bolt (Front Shock Absorber Lower Side) Removal Note
1. Support the knuckle with a jack to prevent it from falling.
Piston Rod Nut Removal Note
Warning:
