Mazdaspeed6 L4-2.3L Turbo (2006)
Suspension Strut / Shock Absorber: Service and Repair
Rear Suspension
Rear Shock Absorber Removal/Installation
REAR SHOCK ABSORBER REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Bracket Installation Note
1. Install the bracket as shown in the figure.
Rear Shock Absorber Inspection
REAR SHOCK ABSORBER INSPECTION
1. Inspect the rear shock absorber in the same way as the front shock absorber.
Rear Shock Absorber Disposal
REAR SHOCK ABSORBER DISPOSAL
1. Dispose the rear shock absorber in the same way as the front shock absorber.