Millenia L V6-2.5L DOHC (1997)
Input/Turbine Speed Sensor: Service and Repair
REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly, battery, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor and tighten to 5.4 - 7.8 Nm (47 - 69 inch lbs.).
7. Connect the input/turbine speed sensor connector.
8. Install the battery, battery carrier, and air cleaner assembly.
9. Connect the negative battery cable.
