Millenia L V6-2.5L DOHC (1997)
ABS Main Relay: Testing and Inspection
Motor Relay (Including Harness to ABS Control Module)
1. Inspect the fail-safe relay.
2. Turn the ignition switch to OFF and disconnect the ABS control module connector.
3. Turn the ignition switch to ON.
4. Connect terminal 2J [2B for ABS/TCS] to a ground.
5. Connect terminal 2H [2A for ABS/TCS] to a ground.
6. Check the following points: Allowing the motor to operate for more than two seconds will damage the motor.
^
If Motor relay in ABS relay does no click when terminals grounded
-
Check harness between motor relay and ABS control module
-
Check motor relay
^
If Motor does not operate
-
Check motor relay
-
Check harness between motor relay and motor
-
Check fuse
7. If not as specified, inspect the wiring harness and the motor relay. See: Motor Relay