Millenia L V6-2.5L DOHC (1997)
At Bottom Dead Point Position In Manual Control
1. Insert the ignition key into the ignition cylinder (ignition ON position).
2. Move the manual switch downward to lower the steering wheel to the bottom dead point position.
3. Leave the connectors connected. Connect the (+) terminal of the voltmeter to the tilt sensor side connector's variable resistance pole side
terminal, (A), (at the back of the connector), and connect the voltmeter's (-) terminal to the body ground side of the connector.
4. If voltage is not approximately 1.4 volts, replace the steering shaft assembly.
