Millenia L V6-2.5L DOHC (1997)
Transmission Mode Switch: Service and Repair
REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the rear console, brake boot panel, and center panel.
3. Remove the indicator panel installation screws.
4. Disconnect the connector and remove the HOLD switch terminals.
5. Remove the selector lever knob assembly.
6. Install a new selector lever knob assembly and tighten to:
Torque: 2.0-2.9 Nm (18-26 inch lbs.).
7. Install the HOLD switch terminals and connect the connector.
8. Install the indicator panel installation screws.
9. Install the center panel, brake boot panel, and rear console.
10. Connect the negative battery cable.
