Millenia L V6-2.5L DOHC (1997)
Dust Seal (Differential Side) (4)
Press in the new differential side dust seal by using a steel plate and the SST.
Joint shaft (3)
Press in the joint shaft by using the SST.
Dust Cover (Differential Side) (1)
1. Mark the shaft as shown in the figure. Length L should be within 89.0 +/-0.5 mm (3.50 +/-0.02 inch).
2. Press in the dust cover to the marked position by using a steel plate and the SST.
3. Verify that length L is within the specification.
