Millenia L V6-2.5L DOHC (1997)
1. Drain the transaxle oil.
2. Follow steps in illustration for removal, referring to the removal note.
3. Install in reverse order of removal, referring to the installation note.
4. After installation, fill the transaxle with the specified amount and type of ATF, and inspect for oil leakage.
Removal Note
Locknut (2)
1. Knock the crimped portion of the locknut outward by using a small chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.
Upper Lateral Link Ball Joint (4)
1. Disconnect the upper lateral link ball joint referring to Steering and Suspension.
2. Suspend the axle assembly as shown in the figure to prevent damage to the link bushing.
Drive shaft (6)
CAUTION: The sharp edges of the drive shaft snap ring can slice or puncture the oil seal. Be careful when removing the drive shaft from the
transaxle.
1. Separate the left-side drive shaft from the transaxle by prying with a bar inserted between the outer ring and the transaxle, as shown in the
figure.