Millenia S V6-2.3L DOHC (Miller cycle) (2000)
/Page-1617001.png)
Dimmer Switch: Testing and Inspection
PANEL LIGHT CONTROL SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Remove the panel light control switch.
3. Measure the resistance of terminals A-B and B-D of the panel light control switch.
4. Verify that the resistance changes from 0 to 100 kOhms as shown in the figure when the panel light control switch is rotated from left to right.
-
If not as specified, replace the panel light control switch.
