Millenia S V6-2.3L DOHC (Miller cycle) (2000)
Fuel Pump Relay: Testing and Inspection
Resistor and Relay Inspection
Resistor
1. Disconnect the fuel pump resistor and relay connector. Measure the resistance between terminals A and B using an ohmmeter.
-
If not as specified, replace the fuel pump resistor and relay (speed).
Specification: 0.38 - 0.42 Ohms.
Relay
Specification
1. Disconnect the fuel pump resistor and relay connector.
2. Apply battery positive voltage and inspect continuity between terminals of the relay using an ohmmeter.
-
If not as specified, replace the fuel pump resistor and relay (speed).