Millenia S V6-2.3L DOHC (Miller cycle) (2000)
/Page-1320001.png)
SAS Control Module: Service and Repair
SAS Control Module
WARNING:
-
Handling the SAS control module Improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR BAG
SYSTEM SERVICE WARNINGS before handling the SAS control module. (See AIR BAG SYSTEM SERVICE WARNINGS.)See: Air Bag
Systems/Air Bag Module/Service Precautions
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS control module to deplete its
stored power.
3. Turn back the floor covering.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position
7. Verify that the air bag system warning light illuminates for approximately 6 seconds then goes off.
-
If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the
inspection again.
