Millenia S V6-2.3L DOHC (Miller cycle) (2000)
Steering Column Position Sensor: Testing and Inspection
TILT SENSOR INSPECTION
CONTINUITY INSPECTION
1. Disconnect the connectors between the tilt sensor and the CPU.
2. Inspect continuity between following terminals of the tilt sensor side connector.
^
If not as specified, replace the steering shaft component.
RESISTANCE INSPECTION
Caution When using the ohmmeter, always make sure that no voltage is applied.
^
If voltage is applied, the ohmmeter may be damaged.
1. Disconnect the connectors between the tilt sensor to the CPU.
2. Measure the resistance between terminal B and terminal C of the tilt sensor side connector.
^
If not as specified, replace the steering shaft component.
Resistance: Approx. 1 k ohms
VOLTAGE INSPECTION
At Top Dead Point Position In Away Auto Control
1. Insert the ignition key into the key cylinder (LOCK position).
2. Turn on the auto switch.
3. Remove the ignition key from the key cylinder to make the steering wheel rise to the top dead point position.