Millenia S V6-2.3L DOHC (Miller cycle) (2000)
/Page-1176005.png)
3. Draw a line 6 mm (0.24 inch) from the bottom of the SST.
4. Position the SSTs on the lower lateral link as shown.
5. Press in the SSTs and bushing down to the line drawn on the SST.
6. Turn the lower lateral link to the opposite side, and position the SSTs as shown.
7. Using the SSTs, press in the bushing until the pressure gauge starts to increase sharply.
DAMPER BUSHING INSTALLATION NOTE
1. Apply soapy water to the new bushing.
2. Insert the new bushing to the lower lateral link (chamfered side).
