Millenia S V6-2.3L DOHC (Miller cycle) (2000)
/Page-1700002.png)
1. Use a molding remover to remove the windshield molding.
Windshield Molding Installation Note
1. Verify that the clips on the body and the molding are not damaged.
-
If they are damaged, replace them as follows:
1. Mark the mounting points of the clips.
2. Remove the clips from the body.
-
If necessary, cut the sealant with a rasor to remove the clips.
-
Do not cut the sealant between the glass and the body.
3. Remove the double-side adhesive tape while heating it with a hot-air blower.
4. Clean and degrease the adhesion surface of the body. Remove any remaining sealant that is not between the glass and the body.
