MPV V6-3.0L DOHC (2002)
^
In case of adjusting to + (positive) side, install the adjusting bolt and washer so that the projection of the washer faces inside (shock absorber
side) as shown.
^
In case of adjusting to - (negative) side, install the adjusting bolt and washer so that the projection of the washer faces outside (steering
knuckle side) as shown.
4. Tighten the nut to the specified torque.
Tightening torque 102.9 - 122.5 Nm (10.50 - 12.49 kgf-m, 75.9 - 90.35 ft. lbs.)
5. Install the wheel and tire, then jack down the vehicle.
6. Shake the vehicle to settle the suspension.
7. Inspect the camber and readjust it if necessary.
Caster Adjustment
1. Jack up the front of the vehicle and support it on safety stands.
2. Remove the mounting block nuts.
Caution:
^
Adjust the caster by turning the mounting block as shown so that the direction indicator is located at position A. If the direction indicator faces
toward the inside of the vehicle, the camber and caster will be out of specifications.
3. Push the mounting block downward, and turn the direction indicator to position A.
Adjustable value -30'.
4. Install and tighten the mounting nuts to the specified torque.
Tightening torque 46.1 - 62.7 Nm (4.71 - 6.39 kgf-m, 34.1 - 46.2 ft. lbs.)
Total Toe-in Adjustment
1. Center the steering wheel and confirm that the vehicle wheels/tires are pointing straight.
2. Remove the steering gear boot clamp.
