MPV V6-3.0L DOHC (2002)
Transmission Speed Sensor: Testing and Inspection
Intermediate Sensor Inspection
On-Vehicle Inspection
1. Disconnect the terminal component No. 2 connector.
2. Measure resistance between the terminals C and D.
^
If not as specified, inspect the intermediate sensor.
Resistance (ATF temperature:
20°C {68°F}) 513 - 627 ohms
3. Connect the terminal component No. 2 connector.
Inspection of Individual Part
1. Remove the intermediate sensor.
2. Measure resistance between the terminals of the input/output speed sensor.
^
If not as specified, replace the intermediate sensor.
^
If it is normal, replace the harness.
Resistance (ATF temperature:
20°C {68°F}) 513 - 627 ohms
3. Install the intermediate sensor.
