MPV V6-3.0L DOHC (2002)
Shifter A/T: Customer Interest
Ignition, A/T - Can't Remove Key From Ignition Lock
TSB: 05-006/06
2002 - 2006 MPV
CANNOT PULL KEY OUT OF IGNITION SWITCH
APPLICABLE MODEL(S)/VINS
2002 - 2006 MPV
DESCRIPTION
On some vehicles, the ignition key cannot be pulled out of the ignition switch after shifting the selector lever into P-range. This occurs from someone
applying excessive force to the selector lever. The guide plate moves out of position causing poor contact in the P-range switch.
Customers having this concern should have their vehicle repaired using the following repair procedure.
REPAIR PROCEDURE
1.
Verify customer concern.
2.
Replace the Change Control (gear selector lever) according to the Workshop Manual (section 05-18 P POSITION SWITCH (BUILT-IN
SELECTOR LEVER) INSPECTION).
3.
Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
NOTE:
^
This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair. Refer to the Warranty Wizard for
warranty term information.
^
Additional diagnostic time cannot be claimed for this repair.
Disclaimer
