MPV 2WD V6-3.0L SOHC (1992)
Wheel Bearing: Service and Repair
4 Wheel Drive
1.
Raise and support vehicle, then remove front wheel.
2.
Remove axle locknut.
3.
Loosen retaining screws and remove brake rotor.
4.
Disconnect outer tie rod from steering knuckle.
5.
Separate lower ball joint from steering knuckle and remove ball joint securing bolts.
6.
Remove knuckle, hub and bearing as an assembly.
7.
Reverse procedure to install, noting the following:
a. Tighten to specifications.
b. Use a new axle locknut.
