MPV 2WD V6-3.0L SOHC (1992)
Ignition Control Module: Testing and Inspection
Igniter Testing
NOTE: This test requires Mazda Special Service Tools (SST) or aftermarket equivalents.
1.
Disconnect igniter connector.
2.
Connect adapter (SST #49 H018 910) between igniter and wiring harness.
3.
Attach 4-pin connector of igniter checker (SST #49 F018 002) to adapter harness.
4.
Connect igniter checker power leads to battery.
5.
Turn ignition switch "ON."
6.
Disconnect high tension coil lead from distributor cap and hold 0.20 - 0.39 in (5 - 10 mm) from a ground.
7.
Flip SW2 "ON" and "OFF" and verify that strong blue sparks are discharged from the high tension lead.
CAUTION:Do not hold SW2 "ON" for longer than one second.
8.
Replace the igniter if it does not perform as specified.
