MPV 2WD V6-3.0L SOHC (1992)
1. Secure the gear housing in a vise so that the lower bearing bore faces upward.
2. Apply ATF to the lower bearing, then install it in the housing.
3. Press the bearing into the gear housing with the housing cover. Tighten the cover until the tightening force suddenly increases.
Pinion shaft and control valve assembly
1. Apply grease (lithium base, NLGI No.2) to the teeth of the pinion shaft.
2. Apply ATF to the seal ring and the friction surface of the control valve.
3. Install the pinion shaft in the housing.
Note: Be careful not do damage the oil seal by the teeth of the pinion. Be careful not to damage the edge of the seal ring and control valve.
Upper bearing
Apply ATF to the upper bearing, then install it
Oil seal
1. Apply ATF to the oil seal, and fill inside the lip with grease (lithium base, NLGI No.2).
2. Slide the SST over the serrations of the pinion shaft assembly.
3. Slide the oil seal over the SST and position it in the housing.
4. Tap the oil seal in with the SST until the snap ring installation groove in the housing is just visible.
Note: Apply uniform force to the oil seal when installing.
