MPV 2WD V6-3.0L SOHC (1992)
1.
Remove terminal holder.
^
Insert a suitable tool between the rear holder and the connector housing (near the locking tab).
^
Pry the tool downward to lift the holder and unhook it
2.
Pull terminals out.
^
Insert a suitable tool into the housing (from the wire end) between the terminal and the locking tab.
^
Lift the locking tab and pull the terminal from the connector housing.
CAUTION:
Take care not to damage terminal.
Do not pull the terminal forcefully, if the terminal is not removed when lightly pulled, repeat the steps above.
3.
Insert female terminals.
^
Insert the terminal in the correct direction until it snaps into place.
^
Confirm that the terminal is locked in place.
NOTE:
If the rear holder is hard to insert, the terminal may be inserted improperly.
