MPV 4WD V6-3.0L SOHC (1990)
1. Without gasket; Apply silicone sealant to the oil pan along the inside of the bolt holes, overlap the ends, and install the oil pan within five minutes.
2. With gasket; Apply silicone sealant to the shaded areas shown in the figure, install a new gasket and the oil pan within five minutes.
Caution: If the bolts are reused, remove the old sealant from the bolt threads. Tightening a bolt that has old sealant on it can cause thread damage.
3. Tighten the oil pan bolts.
Tightening torque: 6.9-9.80 N.m { 70-100 kgf.cm , 61-86.8 in.lbf }.
4. Fill with the specified amount and type of engine oil. (Refer to oil). See: Engine Oil
5. Reconnect the negative battery cable.
6. Start the engine and check for oil leaks.
7. Check the oil level and add oil if necessary.
