MPV 4WD V6-3.0L SOHC (1990)
Throttle Position Sensor: Technical Service Bulletins
Throttle Position Sensor - Revised Inspect & Adjustment
Bulletin No.: 001/94
Issued: 2/18/94
Revised: 3/9/94
Category
F
Applicable Model/s
See Below
Subject:
INSPECTION AND ADJUSTMENT PROCEDURES FOR THE THROTTLE POSITION SENSOR
The revised section of this bulletin is indicated by an asterisk (*). Replace the original bulletin with this revised copy.
APPLICABLE MODELS/VINS
1989-94 MPV
1988-94 929
1990-94 323/Protege
1992-94 MX-3
1990-93 MX-5 MIATA
1992-94 626/MX-6
DESCRIPTION
The following are revised procedures for inspection and adjustment of the throttle position sensor. DO NOT replace the throttle position sensor unless
these instructions have been followed and the results indicate replacement. These instructions are consistent for all of the above models. Please make
your shop personnel aware of this change by copying and distributing this bulletin. Due to the quantity of workshop manuals involved, revisions will be
made as reprinting occurs.
1.
Connect a volt meter to the output terminal for the throttle position sensor at the engine control unit. Refer to the chart.
2.
Turn the ignition on.
