mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Battery - Test Procedures|Page 4070 > < Battery - Test Procedures|Page 4068
Page 1
background image

Battery: Technical Service Bulletins
Battery - Dies In A relatively Short Period Of Time

Bulletin No. 001/98
Issued 10/22/98
Revised

Category
G (01)

Applicable Model/s
All Models except B-Series & Nav.

Subject
DEAD BATTERY (INSPECTING FOR BACK-UP CURRENT)

APPLICABLE MODEL(S)/VINS
All models except B-Series and Navajo.

DESCRIPTION

Battery is dead after vehicle sits overnight or for a short period of time. This could be caused by excessive back-up current drawn through the battery
after the engine is shut off.

Note

^

Back-up current is defined as the current that flows to the memory circuits (i.e. radio, PCM) while the key is out of the ignition and doors are
closed with all lights turned off.

Customers complaining of this concern should have their vehicle repaired using the following procedure.

REPAIR PROCEDURE

1.

Verify customer complaint.

2.

Turn oft all electrical loads (including accessories), remove key from ignition, and close all doors.

Note

^

Disable hood light (if equipped).

3.

To avoid deleting the audio memory presets or OBD-II fault memory, prepare a jumper wire as shown.

4.

Carefully loosen the negative battery clamp without disconnecting it from the post.

Battery - Test Procedures|Page 4070 > < Battery - Test Procedures|Page 4068