MPV DX V6-2.5L DOHC (2000)
B-PILLAR - REAR SLIDING DOOR CONTACTS REPLACEMENT
1.
Open one rear sliding door.
2.
Remove B-pillar lower trim:
NOTE:
If equipped with side seat air bags, the side air bag sensor is located in the B-pillar.
WARNING:
Handling the side air bag sensor improperly can accidentally deploy the side air bag module, which may seriously injure you. Read AIR BAG
SYSTEM SERVICE WARNINGS before working around the B-pillar areas. (See Section 08-10 for AIR BAG SERVICE WARNINGS, and
AIR BAG SERVICE CAUTIONS.)
a.
Remove assist handle (if equipped).
b.
Remove front scuff plate.
c.
Remove rear scuff plate.
d.
Remove rear power sliding door rear switch (if equipped with power sliding doors).
e.
Roll seaming welt over.
f.
Remove bottom fastener.
g.
Disengage clips using a fastener remover tool.
h.
Remove B-pillar lower trim.
3.
Remove seat belt retractor to gain access to rear sliding door connector.
4.
Disconnect connector from rear sliding door contacts.
5.
Remove rear sliding door contacts from B-pillar.
6.
Replace rear sliding door contacts with modified part.
NOTE:
^
Be sure to install contacts with "UP" arrow pointing upward.
^
Check part for "LH" (Left Hand) or "RH" (Right Hand) marking and install on correct side.
7.
Reconnect negative battery cable.
