MPV DX V6-2.5L DOHC (2000)
2.
Attach joint connector to brake line "A" and torque the fitting.
Tightening torque
12.8 - 21.5 Nm (1.3 - 2.2 Kgf.m, 9.4-15.9 ft-lbf)
3.
Install brake line "A" from inside the right front inner fender well and be sure to route the line under A/C lines.
4.
Snap brake line "A" into the two (original) clips "A", but do not tighten or attach the fitting to the flex hose yet.
Note
If clips "A" are broken, replace them with new parts provided.
5.
Install brake line "B" into the revised proportioning valve and finger tighten the fitting.
6.
Mount the proportioning valve to the bulkhead with line "B" attached and finger tighten the bolts.
7.
Install brake line "B" to joint connector and finger tighten the fitting.
8.
Install and torque brake line fittings 1", "2", "3", "4", "5" for the proportioning valve and joint connector.
Tightening torque
12.8 - 21.5 Nm (1.3 - 2.2 Kgf.m, 9.4 - 15.9 ft-lbf)
9.
Tighten and torque the proportioning valve mounting bolts.
Tightening torque
8.9 - 12.7 Nm (90 - 130 kgf.cm, 79 - 112 in-lbf)
