MPV DX V6-2.5L DOHC (2000)
10.
Snap brake line "B" into clips "B".
11.
Install brake line into the flex hose Connection and torque the brake line fitting.
Tightening torque
12.8 - 21.5 Nm (1.3 - 2.2 Kgf.m, 9.4 - 15.9 ft-lbf)
12.
Bleed the brake system using the 2001 MPV Work - shop Manual procedure on page 04-11-3 and INSPECT ALL FITTINGS FOR SIGNS OF
LEAKAGE.
13.
Reinstall the Ignition Coil, Cruise Control Actuator, PRC solenoid and negative battery cable.
14.
Reinstall the right front splash shield and right front tire.
15.
Clean any brake fluid from the underside of the vehicle using water or shop rags.
16.
Road test the vehicle and confirm braking operation is normal. Reset customer's radio station pre-sets.
17.
Reinspect all brake line fittings for leakage. Retighten and re-bleed system if necessary.
C.
AUTHORIZED MODIFICATION LABEL INSTALLATION
Complete an "Authorized Modification Label" with the recall number on it and affix it to driver's side door under the door latch. Refer back
to illustration under "A. VEHICLE VERIFICATION PROCEDURE."
D.
PARTS RETURN POLICY