MPV DX V6-2.5L DOHC (2000)
Crankshaft Main Bearing Seal: Service and Repair
REAR OIL SEAL REPLACEMENT
1. Remove the automatic transaxle.
2. Remove the drive plate.
3. Cut the oil seal lip using a razor knife.
4. Remove the rear oil seal using a screwdriver as shown.
5. Install the rear oil seal with part A of the SST (49 UN01070) and the SST (303-384).
6. Install the studs of the SST (303-384) as indicated in the figure.
7. Apply clean engine oil to the oil seal.
8. Push the oil seal slightly in by hand.
9. Install part A of the SST (49 UN01 070) and compress the oil seal with the nuts of the SST (303-384).
10. Install the drive plate.
11. Install the automatic transaxle.