MPV DX V6-2.5L DOHC (2000)
16.
Move the blend door back and forth to ensure the door is not binding on the plate.
17.
Using a dremel tool, die grinder, or hot knife, remove only the "shaded" portion of the case rib as shown in FIGURE 7.
18.
Remove the case rib portion and shop rags.
19.
Remove all plastic debris from under the blend door and inside the cooling unit with compressed air.
NOTE:
After the modifications have been completed, the cooling unit should appear as shown in FIGURE 8.
20.
Re-assemble the cooling unit in reverse order.
21.
Re-install cooling unit and dashboard assembly in the reverse order of removal.
22.
Re-charge A/C system and confirm that all dashboard and HVAC controls operate properly.
23.
Re-enter customer's radio pre-set stations.
24.
Verify repair.
