MPV DX V6-2.5L DOHC (2000)
Fuel Pressure Pulsation Damper: Service and Repair
Removal/Installation
CAUTION: Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release
connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free
of foreign material.
1. Complete the "BEFORE REPAIR PROCEDURE".
2. Disconnect the negative battery cable.
3. Remove the air cleaner.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Complete the "AFTER REPAIR PROCEDURE".
Plastic Fuel Hose Removal Note
CAUTION: The quick release connector may be damaged when the tab is turned overly. Do not turn the tab over the stopper.
1. Disconnect the quick release connector from the pulsation damper as follows:
1. Push the tab on the orange locking coupler 90° until it stops.
2. Pull the fuel hose straight back.
NOTE:
-
The blue stopper may be removed from the quick connector. Take care not to loose it. Reinstall it to the quick release connector before
reconnecting the fuel line.
-
The orange locking coupler has two internal locking tabs which retain the pulsation damper pipe. Be sure that the tab on the locking
coupler is rotated until it stops to release two internal locking tabs.
