MPV DX V6-2.5L DOHC (2000)
RACK BUSHING ASSEMBLY NOTE
1. After attaching the SST to the end of the steering rack, install the rack bushing to the rack housing.
RACK STOPPER ASSEMBLY NOTE
1. Using snap ring pliers, screw the rack stopper into the rack housing until the hole on the rack stopper lines up with the oblong hole on the rack
housing.
2. Insert the clip into the hole on the rack stopper.
3. Install the rack stopper by turning the rack stopper clockwise.
4. Perform a hermetic sealing inspection.
1. Connect the SSTs to the power cylinder section of the gear housing.
2. Apply 53.3 kPa (400 mm-Hg, 15.7 in-Hg) vacuum with a vacuum pump and verify that it is held for at least 30 seconds.
^
If the vacuum is not held, replace the oil seal.
OIL SEAL (VALVE HOUSING) ASSEMBLY NOTE
