MPV DX V6-2.5L DOHC (2000)
Shift Solenoid: Testing and Inspection
SOLENOID VALVES INSPECTION
Gear Shift Pattern Under Solenoid Valve Failure
Resistance Inspection (on-vehicle)
1. Disconnect the negative battery cable.
2. Connect the SST (104 pin Breakout Box) to the PCM harness with PCM disconnected.
3. Measure the resistance between the terminals of the SST.
-
If not as specified, inspect the ground, then perform resistance inspection (off-vehicle).
ATF temperature: -40 - 160 °C (-40 - 320 °F)
4. Connect the negative battery cable.
Resistance Inspection (Off-Vehicle)
1. Remove the control valve body.
2. Remove the solenoid valve(s).
3. Measure the resistance of each solenoid valve individually.