MPV DX V6-2.5L DOHC (2000)
Transmission Temperature Sensor/Switch: Testing and Inspection
TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION
On-Vehicle Inspection
1. Disconnect the negative battery cable.
2. Connect the SST (1 04 pin Breakout Box) to the PCM harness with PCM disconnected.
3. Remove the oil dipstick.
4. Adjust the depth of the thermistor probe to measure the same as the dipstick.
5. Insert the thermistor probe into the filler tube.
6. Start the engine.
7. Measure resistance between the terminals 37 and 91 of the SST at each ATF temperature.
-
If not as specified, inspect the TFT sensor.
8. Connect the negative battery cable.
Inspection of Individual Parts
1. Remove the TFT sensor.
