MPV ES V6-2.5L DOHC (2001)
Sliding Door Hold-Open Latch Actuator: Service and Repair
Lock Actuator
SLIDING DOOR LOCK ACTUATOR REMOVAL/INSTALLATION
1. Close the rear door glass completely.
2. Disconnect the negative battery cable.
3. Remove the door screen.
4. Disconnect the sliding door lock actuator connector.
5. Disconnect the rods and the cables.
6. Remove the bolts, and remove the sliding door remote controller.
7. Remove the screws, and remove the sliding door lock actuator from the sliding door remote controller.
8. Install in the reverse order of removal.