MPV ES V6-2.5L DOHC (2001)
2. Measure the resistance between MAF/IAT sensor terminals A and F using an ohmmeter.
-
It not as specified, replace the MAF/IAT sensor.
-
If the IAT sensor is okay, but the IAT and the IAT V PID are out of specification, perform the "IAT Sensor Circuit Open/Short Inspection".
IAT Sensor Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Connect the SST (104 Pin Breakout Box) without connecting to the PCM as shown.
3. Tighten the connector attaching bolt.
Tightening torque
3.0 - 5.4 N.m {30 - 56 kgf.cm, 27 - 48 in.lbf)
