Testing and Inspection for Transmission Position Switch/Sensor
12. Align the protrusion and neutral mark as shown.
13. install the TR switch while aligning the protrusion and groove as shown.
14. Turn the TR switch so that the neutral mark is in line with the flat, straight surfaces on either side of the manual shaft.
15. Hand-tighten the TR switch bolts.
16. Perform the TR switch adjustment.
17. Install the manual shaft lever and washer.
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when tightening the manual shaft nut, or the transaxle may be damaged.
18. Set the adjustable wrench as shown to hold the manual shaft lever.
19. Tighten the manual shaft nut using a torque wrench.
Tightening torque 32 - 46 Nm (3.2 - 4.7 kgf-m, 24 - 33 ft. lbs.)
