MPV ES V6-2.5L DOHC (2001)
Impact Sensor: Service and Repair
SIDE AIR BAG SENSOR REMOVAL/INSTALLATION
WARNING: Handling the side air bag sensor improperly can accidentally deploy the side air bag module, which may seriously injure you.
Read AIR BAG SYSTEM SERVICE WARNINGS before handling the side air bag sensor. (See AIR BAG SYSTEM SERVICE WARNINGS.)
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the B-pillar lower trim.
4. Remove in the order indicated below.
1. Bolt
2. Connector
(See Connector Removal Note)
(See Connector Installation Note)
3. Side air bag sensor
5. Install in the reverse order of removal.
NOTE: When a new side air bag sensor has been installed, perform the air bag module deployment authorization procedure. (See AIR BAG
MODULE DEPLOYMENT AUTHORIZATION PROCEDURE.)
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
-
If the air bag system warning light does not operate in the manner described above, there are malfunction in the system. Inspect the system
using the on-board diagnostic function. (See FOREWORD.)
Connector Removal Note
-
Slide the connector cover toward the harness and then disconnect the connector from the side air bag sensor.