MPV ES V6-2.5L DOHC (2001)
1. Mark the lower arm as shown in the figure by aligning with the small projection of the lower arm bushing (rear) for proper installation.
2. Remove the lower arm bushing using the SSTs and a press.
Lower Arm Bushing (Rear) Installation Note
1. Align the mark of the lower arm and the small projection of the lower arm bushing (rear) as shown in the figure.
2. Set the lower arm onto the SST (49 L034 201).
3. Press the new lower arm bushing using the SST (49 L034 202).
Lower Arm Bushing (Front) Installation Note
1. Install a new bushing, and pull it into the lower arm using the SST.
Dust Boot Installation Note
1. Wipe the grease off the ball stud.
2. Fill the inside of the new dust boot with grease.
