MPV ES V6-2.5L DOHC (2001)
Axle Shaft: Service and Repair
Short Shaft
Removal and Installation
JOINT SHAFT REMOVAL/INSTALLATION
Caution:
-
Performing the following procedures without first removing the ABS wheel-speed sensor could cause an open circuit in the harness if it is pulled
by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where
the sensor will not be pulled by mistake while servicing the vehicle.
-
Removing the drive shaft with the joint shaft bracket installed may cause the deformation of the joint shaft bracket. Therefore remove/install the
drive shaft and joint shaft as a component.
1. Drain the transaxle oil.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Lower Arm Ball Joint Removal Note
1. Remove the clinch bolt and nut.