MPV ES V6-2.5L DOHC (2001)
Transmission Speed Sensor: Service and Repair
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the battery, battery tray, and battery carrier.
3. Remove the air cleaner component.
4. Disconnect the input/turbine speed sensor connector.
5. Remove the input/turbine speed sensor.
6. Apply ATF to a new O-ring and install it on the input/turbine speed sensor.
7. Install the input/turbine speed sensor.
Tightening torque 7.8 - 11.0 Nm (79 - 113 kgf-cm, 68.6 - 98.0 inch lbs.)
8. Connect the input/turbine speed sensor connector.
9. Install the air cleaner component.
10. Install the battery carrier, battery tray, and battery
11. Connect the negative battery cable.
