MPV ES V6-2.5L DOHC (2001)
6. Fit the molding at upper corners. (3)
7. Install the molding at left and right side, then upper side. (4)
8. Adjust the fitting of each corner. (5)
9. Paste the fasteners onto the body as shown.
10. Install the spacer and fasteners onto the glass as shown.
CAUTION: Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass
and body, which may cause leaks to occur.
11. Use a brush to apply primer to the bonding area of the glass, the body and the molding within the region shown. Use only glass primer on the
glass, and body primer on the body and the molding. Allow it to dry for approximately 30 minutes.
