MPV ES 4WD V6-3.0L SOHC (1997)
7. Remove the HLA.
^
Remove the HLA by hand. If this is difficult, remove it with pliers.
CAUTION: Do not remove the HLA unless necessary because oil leakage will occur if the O-ring is damaged.
INSTALLATION
1. Install the HLA.
a. Pour engine oil into the oil reservoir in the rocker arm.
b. Apply engine oil to the HLA.
c. Carefully install the HLA into the rocker arm.
2. Install the rocker arm and rocker arm shaft.
CAUTION: Be careful that the rocker arm shaft spring does not get caught between the shaft and mounting boss during installation.
a. Install the rocker arm and rocker arm shaft.
b. Tighten the bolts in the order shown.
Tightening torque: 18-26 Nm (14-19 ft lbs.)
3. Install the cylinder head cover.
Tighten to 3.5-4.4 Nm (31-39 inch lbs.)
