MPV ES 4WD V6-3.0L SOHC (1997)
Head Torque Sequence
(2) Tighten the bolts in the order shown.
Tightening torque: 17.2-22.0 Nm (12.7-16.2 ft lbs.)
(3) Put a paint mark on each bolt head.
(4) Using the mark as a reference, tighten the bolts 85°-95° in the sequence shown.
(5) Retighten each bolt another 85°-95° in the sequence shown.
2. Install the seal plate.
3. Install the exhaust manifold.
4. Install the exhaust manifold insulator.
5. Install the center exhaust pipe.
6. Install the exhaust pipe insulator.
7. Install the cylinder head cover.
a. Remove all old silicone sealant from the cylinder head and cylinder head cover.
b. Coat a new gasket with silicone sealant, and install it onto the cylinder head cover.
c. Install the cylinder head cover along with new seal washers.
Tightening torque: 3.5-4.4 Nm (31-39 in lbs.)
8. Install the intake manifold.
9. Install the timing belt.
10. Fill the radiator and coolant reservoir with the specified amount and type of engine coolant.
11. Connect the negative battery cable.
12. Start the engine and check the following:
^
check the engine oil and engine coolant leakage.
^
check the ignition timing and idle speed.
13. Check the compression.
