MPV ES 4WD V6-3.0L SOHC (1997)
Without ABS
CAUTION: If the oil seal is not properly pressed onto the axle casing, oil leakage will occur. Always use the SSTs when installing the oil
seal.
Apply grease to the lip of a new oil seal, then press it onto the axle casing by using the SSTs until the oil seal is 1.5 - 2.0 mm (0.06 - 0.07
inch) from the end of the casing.
Rear Axle Shaft (7)
Install the dust cover and rear axle shaft component by using the SSTs.
Overhaul
DISASSEMBLY / ASSEMBLY
1. Disassemble in the order indicated in the illustration, referring to disassembly note.
2. Assemble in the reverse order of disassembly indicated in the illustration, referring to assembly note.
Disassembly Note
