MPV ES 4WD V6-3.0L SOHC (1997)
Window Seal: Service and Repair
Drip Molding
Rear
Removal
Remove the front drip molding by pulling on it.
Installation
1. Align the rear end of the front drip molding with the front end of the rear drip molding (A).
2. Install the front drip molding from the rear toward the front end (B).
Side
1. Remove the rear side beltline molding.
2. Remove the front drip molding.
3. Pull the rear drip molding forward to disengage the clips from the body, and remove the rear drip molding.
4. Install in the reverse order of removal.