MPV LX V6-2.5L DOHC (2000)
1. Cut away the old sealant using a razor so that 1 - 2 mm {0.04 - 0.07 in} thickness of sealant remains around the circumference of the frame.
-
If all the sealant has come off in any one place, apply some primer after degreasing, and allow it 30 minutes to dry. Then put on new sealant to
create a 2 mm {0.08 in} layer.
2. Clean and degrease an approximately 50.0 mm {1.97 in} wide strip around the circumference of the glass and the bonding area on the body.
3. Clean and degrease the ceramic parting of the glass and the bonding area on the body.
4. Fit the molding at lower corners. (1)
5. Install the molding at lower side. (2)
6. Fit the molding at upper corners. (3)
7. Install the molding at left and right side, then upper side. (4)
8. Adjust the fitting of each corner. (5)
9. Paste the fasteners onto the body as shown.
