MPV LX V6-2.5L DOHC (2000)
Air Bag Module: Service and Repair
Driver-Side Air Bag Module
Removal and Installation
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR
BAG SYSTEM SERVICE WARNINGS before handling the air bag module. (Refer to AIRBAG SYSTEM SERVICE WARNINGS.)
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
If the air bag system warning light does not operate in the manner described above, there are malfunctions in the system. Inspect the system using
the on-board diagnostic function.
Connector Installation Note
Install the connector as shown in the figure.
Deployment Procedures For Inside of Vehicle
WARNING: A live (undeployed) air bag module may accidentally deploy when it is disposed of and cause serious injury. Do not dispose of a
live (undeployed) air bag module. If the SSTs (Deployment tool and Adapter harness) are not available, consult the nearest Mazda
representative for assistance.
