MPV LX V6-2.5L DOHC (2000)
CAUTION: Deploying the air bag modules inside the vehicle may cause damage to the vehicle interior. When the vehicle is not to be scrapped, always
deploy the air bag modules outside the vehicle.
When the vehicle is to be scrapped, deploy the air bag modules inside the vehicle. (Refer to Deployment Procedure for inside of vehicle.)
When the vehicle is not to be scrapped, deploy the air bag modules outside the vehicle. (Refer to Deployment Procedure for Outside of Vehicle.)
NOTE: When disposing of a deployed air bag module, refer to air bag module disposal procedure. (Refer to AIR BAG MODULE DISPOSAL
PROCEDURE.)
Deployment Procedure for Inside of Vehicle (only when vehicle is to be scrapped)
1. Inspect the SST (Deployment tool). (Refer to INSPECTION OF SST (DEPLOYMENT TOOL).)
2. Move the vehicle to an open space, away from strong winds, and close all of the vehicle's doors and windows.
3. Turn the ignition switch to LOCK position.
4. Disconnect the negative battery cable and wait for more than 1 minute.
5. Follow the appropriate procedure for deploying the driver-side air bag module, passenger-side air bag module.
Driver-side air bag module
1. Remove the column cover.
2. Disconnect the clock spring connector.
3. Connect the SST (Adapter harness) to the clock spring as shown in the figure.
4. Connect the SST (Deployment tool) to the SST (Adapter harness).
5. Connect the red clip of the SST (Deployment tool) to the positive battery terminal and the black clip to the negative battery terminal.
6. Verify that the red light on the SST (Deployment tool) is illuminated.
7. Make sure all persons are standing at least 6 m {20 ft} away from the vehicle.
8. Press the activation switch on the SST (Deployment tool) to deploy the driver-side air bag module.
Deployment Procedures For Outside of Vehicle
